Toys can be used to detect the location of touch on the existence of a safety hazard sharp cusp.
Meet the criteria:
ASTM F963 4.8, EN71-1998 8.12, GB6675-2003 A.5.9, 16 CFR 1500.48
Test procedure:
1, sharp point tester set-up program
1.1, release the lock ring clockwise rotation.
1.2, clockwise rotation test cap, until the red indicator light.
1.3, counter-clockwise rotation test cap slowly, until the light just go out.
1.4, forward / post-rotation test cap, to determine when the indicator light is just the exact location.
1.5, refer to the lock ring marked by the scale lines, and test cap in which a scale-line alignment.
1.6, counter-clockwise rotation test cap 5 grid scale lines (two short-term cap on the distance between a cell).
1.7, twisted tight-locked loop, until close to the end caps.
2, sharp-point test procedures
Cutting-edge into the tip-point tester measuring tank, hold the test material and exert force 4.5N to check whether the bright lights. If we allow the free cusp tester vertical, not to impose external force, this time imposed by the external force measured object is 4.5N (1LBS).
3, to determine: If the lights, the measured object for the unqualified products, namely, sharp point.
Application type: wooden toys and children 96 months and the following apply to toys. |
|
|
|
| Select Image |
 |
|
|
|
|
